Advertisement
为使安装顺利袁G1/2" 内螺纹管
道配件应已安装好遥 预留
150mm 的间距袁保持水平袁并垂
直墙面袁低于和高出墙面的长度
不超过 5mm遥 热供水管装在左
边遥
在两个接头渊1冤涂上螺纹密封或
缠绕足以密封的密封胶带袁旋入
冷热供水管中遥
调节两个接头袁使其中心距离为
150mm 并保持同一水平遥 它们
凸出墙面的尺寸应该在 40 到 47
毫米之间遥 在装饰罩背面边缘涂
一圈油灰袁将装饰 罩渊2冤 旋入接
头袁紧贴装修后的墙壁遥 去除多余
油灰遥
将垫片渊3冤放入螺母渊4冤中袁把螺
母旋到接头渊1冤上袁用带状扳手锁
紧遥
去掉出水口(5)保护套遥
手持花洒渊8冤的限流器不可取出遥
取出软管(7)一端接头内的垫片遥
将滤网垫片渊6冤放入软管接头内袁
毡垫渊9冤放入手持花洒内袁将手持
花洒旋紧到软管上袁软管另一端
连接出水口(5)遥
1130591-2-A
COLD
冷
HOT
热
2
1
3
4
5
7
To perform installation, installer must provide
G1/2" female supply fittings, spaced 150mm
apart, level, vertical, and not more than 5mm
if extending or below the finished wall
surface. Hot supply pipe must be located on
the left.
Install the two offset connectors(1) into the
hot and cold supply fittings. Use appropriate
thread sealants or thread tape onto the
threads.
Adjust the center-to-center distance between
the connectors to 150mm and level. They
should extend 40 to 47 mm beyond the
finished wall. Apply a ring of plumbers putty
around the back edge of the escutcheons(2).
Thread escutcheons(2) onto the connectors
until they are against the finished wall.
Remove any excess putty.
Put the washers(3) into the nuts(4). Thread
the nuts onto the connectors(1) and tighten by
the strap wrench.
Remove the guard on the outlet(5).
Don't remove the regulator of handspray(8).
8
Remove the washer from one connector of
9
the hose(7). Put the screen washer(6) into
6
the shower hose connector, put the filter(9)
into the handspray, screw the handspray to
the shower hose. Connect another end of
shower hose to the faucet outlet(5).
Advertisement
