Beko 191625 ESC User Manual page 43

Important instructions regarding safety and environment
A
1.3 - Electrical safety
The product must be unplugged during installa-
tion, maintenance, cleaning, repairing and mov-
ing procedures.
If the power cable is damaged, it must be re-
placed by a qualified person specified by the
manufacturer, authorised service agent or im-
porter in order to avoid potential dangers.
Do not squeeze the power cable under or be-
hind the product. Do not place heavy objects on
the power cable. Power cable must not be bent
excessively, pinched or get in contact with any
heat source.
Do not use extension cords, multi-sockets or
adapters to operate the product.
Portable multi-sockets or portable power
sources can overheat and cause fire. Therefore,
do not keep any multi-sockets behind or near
the product.
Plug must be easily accessible. If this is not
possible, the electrical installation to which the
product is connected must contain a device
(such as a fuse, switch, circuit breaker, etc.)
which conforms to the electrical regulations and
disconnects all poles from the grid.
Do not touch the power plug with wet hands.
Remove the plug from the socket by gripping
the plug and not the cable.
A
1.4 - Transportation safety
Product is heavy; do not move it alone.
Do not hold its door when moving the product.
Pay attention not to damage the cooling system
or the piping during transportation. If the piping
is damaged, do not operate the product and call
the authorised service agent.
A
1.5 - Installation safety
Call the authorised service agent for installation
of the product. To make the product ready for
use, check the information in the user manual
to make sure that the electricity and water instal-
lations are suitable. If they are not, call a qualified
electrician and plumber to have the necessary
arrangements made. Otherwise, there is the risk
of electric shock, fire, problems with the product,
or injury!
Prior to installation, check if the product has any
defects on it. If the product is damaged, do not
have it installed.
Place the product on a clean, flat and solid
surface and balance it with adjustable feet.
Otherwise, the product may tip over and cause
injuries.
The installation location must be dry and well
ventilated. Do not place carpets, rugs or similar
covers under the product. Insufficient ventilation
causes the risk of fire!
Do not cover or block the ventilation openings.
Otherwise, power consumption increases and your
product may get damaged.
Product must not be connected to supply systems
such as solar power supplies. Otherwise, your
product may get damaged due to sudden voltage
changes!
The more refrigerant a refrigerator contains,
the larger the installation location must be. If
the installation location is too small, flammable
refrigerant and air mixture will accumulate in
cases of refrigerant leakage in cooling system.
The required space for each 8 gr of refrigerant is
1 m³ minimum. The amount of refrigerant in your
product is indicated on the Type Label.
Product must not be installed in places exposed to
direct sunlight and it must be kept away from heat
sources such as hobs, radiators, etc.
If it is inevitable to install the product close to a heat
source, a suitable insulation plate must be used in
between and the following minimum distances must
be kept to the heat source:
- Minimum 30 cm away from heat sources such
as hobs, ovens, heater units or stoves,
- Minimum 5 cm away from electric ovens.
Protection class of your product is Type I. Plug
the product in a grounded socket that conforms
the voltage, current and frequency values stated
on the type label of the product. The socket must
be equipped with a 10 A – 16 A circuit breaker.
Our company shall not be liable for any damages
4 / 32 EN
Refrigerator / User Manual