Hydrafeed Multifeed 65 Manual page 5

1. READ COMPLETE INSTRUCTIONS BEFORE OPERATING BARFEED
When this instruction manual was printed the information was correct. Since we are
constantly improving the design it is possible however that the illustrations and
descriptions may vary from the Barfeed supplied.
The Barfeed is designed and built for maximum ease of use and safety of operation.
However, some previously accepted shop floor practices might not reflect current
safety regulations and procedures and should be re-examined to ensure compliance
with same.
It is recommended that all works supervisors, maintenance personnel and machine
tool operators be advised of the importance of safe maintenance, set-up and
operation of Hydrafeed equipment. Our recommendations are listed below.
SAFETY POINTS AND AWARENESS
Before any operation of the Barfeed the following safety awareness must be
observed, failure to do so could result to injuries to the operator.

Read the appropriate manual or instructions before attempting operation or maintenance of
the Barfeed. Ensure you understand all instructions.

Consult your supervisor when in doubt as to the correct way to do the job.

Do not remove any warning or instruction tags from the machine.

Disconnect main electrical power before attempting any repair or maintenance.

Do not reach into any control or power case area unless electrical and pneumatic power is off.

Do not touch electrical equipment when hands are wet or when standing on wet surface.

Keep chemical and flammable material away from electrical or operating equipment.

Do not use a toxic flammable substance as a solvent cleaner or coolant.

Be sure to know where all stop buttons are located in case of emergency.

Any electrical connection that is to be carried out to the Barfeed should be a qualified and
competent electrical engineer.

When the Barfeed is in operation, under no circumstances should any personnel put his or
hers hands or other objects inside the Barfeed and that the electrical cabinet is not to be
opened or any of the wires, components or electrical devices are to be interfered with.

When the Barfeed is in operation, carrying out any adjustment, servicing, cleaning or any
physical interaction is strictly forbidden.

Be sure to disconnect main electrical supply to the Barfeed before any mechanical or electrical
repair or maintenance is performed.

Do not operate this Barfeed unless proper maintenance has been regularly carried out and
that the equipment is in good working order.

Do not operate the Barfeed if there is any unusual noise or if there is heat, smoke or vibration
taking place. Any of these occurrences and damaged components is to be reported.

Do not allow untrained personnel to operate or carry out any repairs to the Barfeed.

Do not operate the Barfeed with safety guard's open and not to override safety devices and
not leave lose components, parts, tools, etc on or inside the Barfeed.

Make certain that all Barfeed guards are in good condition and are functioning properly before
operating the machine.

Do not operate any equipment while any part of the body is in the proximity of a potentially
hazardous area.

Before proceeding auto cycle, be sure that all data and functions have been entered.

Be sure to follow instructions and alarms, which are generated, via the screen

If STRICT COMPLIANCE with the above safety procedures is not undertaken, Hydrafeed
Limited cannot accept responsibility for any accident thus incurred.
FOR YOUR OWN PROTECTION - WORK SAFELY
.
5