Table Of Contents - Hydrafeed Multifeed 65 Manual

CONTENTS
Section 1 Safety Requirements..........................................................................
Section 2 Barfeed Installation......................................................................
3.0 Site Preparation....................................................................................
3.10 Delivery and Inspection of Barfeed............................................................
3.20 Positioning of Barfeed...........................................................................
3.30 Alignment Procedure............................................................................
3.40 Operation of Barfeed............................................................................
Section 3 Barfeed Mechanism
4.1 The Barfeed Master Spindle Reduction Liner system.......................................
4.2 Fitting Master Spindle Reduction Liner with BSU...........................................
4.3 Fitting Master Liner & Correct Sized Bored Bushings.......................................
4.4 Height Adjustment of the Support Channel....................................................
4.5 Bar Stops & Adjustments........................................................................
4.6 Changing or Removing the Push Rod...........................................................
Section 4 External Electrical Devices
5.1 Pusher forward movement sensor...............................................................
5.2 Location of Cross slide sensors..................................................................
5.3 Location of Bushing sensor......................................................................
5.4 Location of Guard sensor.........................................................................
5.5 Location of Material sensor......................................................................
5.6 Location of Cylinders sensors....................................................................
Section 5 Pneumatic Devices
6.1 Location of Loader cylinder.....................................................................
6.2 Location of Cross slide cylinder.................................................................
Section 6 Pneumatic Control Devices
7.1 Location of Cross slide and Cam adjustment valves.........................................
7.2 Pusher adjustment valve.........................................................................
7.3 Location of air pressure Regulator..............................................................
7.4 Schematic of pneumatic system.................................................................
Section 7 Electrical Signal
8.1 Input and Output signals and descriptions.....................................................
2