Advertisement
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for xtures.
Prima is not responsible for any xture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima's catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer speci cs. Prima is not responsible for any damage caused by improper
dimmer speci cation and usage. Use only quali ed electrician for installation. Adhere to all local and national electrical codes prior to installation.
t II system two piece power feed
It is strongly recommended that gloves are used when handling the FIT II System track. Oils and dirt from ngers can sometimes permanently
mark the nish. Track should be cleaned with a damp cloth and thoroughly dried before xture installation.
HOT
Wire must be fed
Designed only for the
bottom track in the
vertical orientation.
HOT Installation Instructions
Ensure that the top knurled knob is
L1
raised as much as possible prior to
installation.
Neutral Installation Instructions
Ensure that there is NO gap in between
M1
both knurled knobs prior to installation.
NOTE:
1. Both the Neutral and the Hot must be inserted into the same track in order to receive voltage.
2. Test Voltage and Temperature after installation to ensure proper installation and conductivity.
3. Remove the power feed before moving to ensure nish of track.
CAUTION
Always disconnect power prior to installation
or maintenance.
Wire must be fed
Designed only for the
bottom track in the
vertical orientation.
Insert the power feed into the track and
L2
rotate the top knurled knob counter
clockwise until the feed rest
perpendicular to the track.
Insert the power feed into the track and
M2
rotate the bottom knurled knob
counter clockwise until the feed rest
perpendicular to the track.
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
(22-79300-2)
NEUTRAL
L3
M3
Voltage & Temperature Readings
Voltage: 11.3V 1 11.7V w/ 85% to 90% load
Temperature: 80° - 90°F Room Temperature
This additional piece is
necessary for Fit II
application.
Rotate the bottom knurled knob
counter clockwise to tighten and
secure the contact. The gap between
the two knurled knobs should now be
smaller.
Rotate the top knurled knob counter
clockwise to tighten and secure the
contact. There should now be a gap
between the two knurled knobs.
REV. 052416
Advertisement
