Advertisement
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for xtures.
Prima is not responsible for any xture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima's catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer speci cs. Prima is not responsible for any damage caused by improper
dimmer speci cation and usage. Use only quali ed electrician for installation. Adhere to all local and national electrical codes prior to installation.
t II system xture adapter installation
It is strongly recommended that gloves are used when handling the FIT II System track. Oils and dirt from ngers can sometimes permanently
mark the nish. Track should be cleaned with a damp cloth and thoroughly dried before xture installation.
C
FIT II System adapter are installed in the track using a twist-and-lock method. The adapter is inserted at the desired location on the track
length. Pressure is applied on the adapter to compress the internal contact/pressure mechanism. While applying said pressure, the
adapter is rotated 90º clockwise until it stops. To secure the adapter, the knurled locking ring is rotated clockwise by hand until suf cient pressure
creates a solid and secure mounting. IMPORTANT: Do not attempt to slide the adapter to other locations on the track length after it is installed. The
adapter must be completely removed from the track slot and reinstalled at the new location.
Insert the adapter into the
track slot
C1
support. The following steps cover the general task of inserting the support adapter into the track slot. See the individual steps for various
support method installation instructions. It is strongly recommended that gloves are used when handling the FIT II System track. Oils and dirt
installation.
FIT II System support adapters are installed in the track using a twist-and-lock method. The support adapter is inserted at the desired
D
location on the track length. The adapter is rotated 90º clockwise until it stops. To secure the adapter, the knurled locking ring is rotated
on the track length after it is installed. The adapter must be completely removed from the track slot and reinstalled at the new location.
D1
FIT II SYSTEM TRACK REQUIRES SUPPORT POINTS BE INSTALLED EVERY 4'
Apply pressure and
rotate 90º clockwise
Black top knob is for
locking purposes.
C2
Hold the bottom knob with
Ensure that there is
your fingers. Do not use a
no gap between
plier or any other tools that
the knurled knobs
before installation.
will hurt the adapter and finish.
Apply pressure and
rotate 90º clockwise
D2
Ensure that there is
no gap between
the knurled knobs
before installation.
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
After rotation,
adapter rests
inside track slot.
C3
C4
After rotation,
adapter rests
inside track slot.
D3
D4
Rotate knurled
locking ring
clockwise to
secure the adapter.
There should now
be a gap between
the two knobs.
C5
(22-79293, 22-65390 ~ 22-65398)
l mounted
ure
to other locations
D5
Rotate knurled
locking ring
clockwise to
secure the adapter.
There should now
be a gap between
the two knobs.
REV. 052416
Advertisement
