Advertisement
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wa
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima's catalogs provide general information and suggestions for proper dimmer usage. Please consult
Support points are required along the FIT System track run at 4ft maximum intervals. When using connectors, supports must be installed on the connector
or within 6" of the connector. Additional supports may be required when using certain glass pendants. It is strongly recommended that gloves are used when
handling the FIT II System track. Oils and dirt from ngers can sometimes permanently mark the nish. Track should be cleaned with a damp cloth and thoroughly
dried before xture installation.
Be sure that the items indicated below are included in the package. Insert the Track Support End Mount to the end of the track, and tighten
E
it with a screw driver. Do both ends before mounting it on the ceiling. Mount screw anchor at the desired place, and use a mounting screw
to tighten it and cover the screw with the support cap.
for end mounting point
Anchors
Mounting
screws
Track Support End Mount
Support Cap
*Caution:
Do not break the insulator inside
the chamber while using the
screw-in function. Broken insulator
will cause short of circuit.
F
Use 22-79140 supporting clip for surface mount option.
WARNING: DO NOT ATTACH METAL CLIP TO ANY METAL CEILING, T-BAR, OR TRUSS
22-79140
E1
E3
Insert the screw anchor, and tighten the screw
WOOD CEILING ONLY.
F1
F2
Ensure that there is
no gap between
the knurled knobs
before installation.
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
F3
F4
Apply pressure and
After rotation,
rotate 90º clockwise
adapter rests
inside track slot.
atest updates on
improper
s prior to installation.
(22-79131)
Insert the Track Support End Mount to the
end of the track, and tightened the screw
with a screwdriver.
E2
F5
Rotate knurled
locking ring
clockwise to
secure the adapter.
There should now
be a gap between
the two knobs.
REV. 082217
Advertisement
