Advertisement
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for xtures.
Prima is not responsible for any xture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima's catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer speci cs. Prima is not responsible for any damage caused by improper
dimmer speci cation and usage. Use only quali ed electrician for installation. Adhere to all local and national electrical codes prior to installation.
It is strongly recommended that gloves are used when handling the FIT II System track. Oils and dirt from ngers can sometimes permanently
mark the nish. Track should be cleaned with a damp cloth and thoroughly dried before xture installation.
Determine whether the FIT II track length will be installed as
A1
part of a series of connected track lengths or as a single
stand alone track length. Before attempting to eld cut the FIT track,
ensure that the end caps are rmly installed into both ends. If an end
cap has become loose during shipping, replace it.
t II system track connector/powerfeed basics
Connectors are available for extending track length, turning corners or creating intersections in the run. Great care must be taken to ensure
the connector is installed properly.
B1
FIT II track is constructed of an aluminum housing which
doubles as the neutral conductor. The slot of the track includes
one conductor and one insulator. The slots may used as two separate
circuits with the proper use of power feeds.
When installing a connector at the end of a FIT II track length,
B3
great care should be taken to ensure the connector is properly
installed. After the connector has been inserted into the end of the track,
inspect the opposite end of the track. If the inslulators and conductors
are ush with the end, then the installation was successful. If the
conductors protrude past the end of the track AT ALL then connector is
not properly installed.
FIT II System track
may not be bent
Opposite end after a
proper connector installation.
*Caution:
Do not break the insulator inside
the chamber while using the
screw-in function. Broken insulator
will cause short of circuit.
Insulator
Conductor
Track housing/
Neutral
Opposite end after an
improper connector installation.
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
(22-79111, 22-79113)
FOR FIELD CUTTING. Cut the track so that the desired e ect
A2
and lengths can be achieved. FIT II track may be eld cut with
an ordinary hacksaw. Be sure to use a FINE-TOOTH METAL CUTTING
BLADE. Be sure to deburr and clean all cuts prior to nal assembly.
FIT II SYSTEM TRACK
MAY NOT BE BENT IN
ANY WAY
B2
When installing a connector or power feed, place the opposite
end of the track length against a solid at surface to keep the
internal parts of the track from sliding. Carefully align the connector pins
on the connector with the holes in the track's conductors. Insert the
connector all the way into the track until it stops.
*Caution
When the connector or power feed is properly inserted into the
B4
track length, secure the installation by tightening the lock
screws located at the top or bottom of connector. DO NOT
OVERTIGHTEN THE SCREWS.
REV. 052416
Advertisement
