Related Manuals for Clarke STRONG-ARM HLPT550
Summary of Contents for Clarke STRONG-ARM HLPT550
- Page 1 HIGH-LIFT PALLET TRUCKS Models; HLPT550 & HLPT685 Part Nos 7630180 & 7630185 OPERATING & MAINTENANCE INSTRUCTIONS GC12/11...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE High Lift Pallet Truck. This truck is designed to raise and lower awkward or heavy loads to an operating height where they may be handled with relative ease, avoiding the risk of injury which might otherwise occur if manhandling the load to the same height. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS 1. Keep the work area tidy & well lit and keep children and bystanders away from the work area. 2. Never carry out any alterations or modifications to the pallet truck. 3. Do not exceed the stated capacity of the truck. Refer to the technical specifications on page 6 and the labelling on the pallet truck. - Page 4 ASSEMBLY Attach the handle assembly as follows: Fig. 1 1. Lower the chain through the hole in the handle bracket, so that it emerges at the bottom of the housing as shown in Fig 1. 2. Secure the handle to the base bracket with the three socket- headed screws and spring washers...
-
Page 5: Operation
ADJUSTMENT The control lever has three positions To Lower shown in Fig 4 and indicated by the label on the handle. Transport With the lever pulled to the upper position position, the forks will lower. To Lift The middle position allows the load to be transported. -
Page 6: Maintenance
the forks and is completely stable. Ensure there is no obstruction before raising the load, or that the load cannot foul the truck mechanism when raised. Lower the forks to the lowest height when the truck is not being used. When lowering the truck with the forks loaded, pull the control lever up carefully and gradually so that the load descends under complete control. -
Page 7: Troubleshooting
For parts & servicing, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com... - Page 8 PARTS LIST & DIAGRAM - PUMP n i l k i r...
- Page 9 PARTS LIST & DIAGRAM - PUMP...
- Page 10 PARTS LIST & DIAGRAM - FORK FRAME l l i n i l n i l n i l n i l l l u...
-
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY...
Need help?
Do you have a question about the STRONG-ARM HLPT550 and is the answer not in the manual?
Questions and answers