Maintenance - Panasonic S-45MK2E5A Operating Instructions Manual

Maintenance

For safety, be sure to turn the air conditioner off and
z
disconnect the power before cleaning. (Otherwise,
electric shock or injury may result because the fan is
rotating at high speed.)
Do not pour water on the indoor unit. (This may damage
z
the internal components and cause an electric shock
hazard.)
The internal coil and other components of the outdoor unit must be cleaned periodically.
z
• Consult your dealer or service center.
„ Air Filter Maintenance
It is recommended that the air fi lter be cleaned when
the (Filter) appears on the display. Clean the fi lter
frequently for best performance in the area of dusty or
oil spots regardless of fi lter status.
„ Cleaning
Cleaning instructions :
• Do not use benzene, thinner or scouring powder.
• Use only soap (
• Do not use water hotter than 40°C.
Indoor unit :
Wipe the unit gently with a soft, dry cloth.
Air fi lters :
• Air fi lters cleaning is needed every two weeks.
• Wash/rinse the fi lters gently with water to avoid
damage to the fi lter surface.
• Dry the fi lters thoroughly under the shade, away from
fi re or direct sunlight.
• Replace any damage fi lter.
NOTE
• Clean the fi lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
„ How to remove
Front panel
1
6
WARNING
pH7) or neutral household detergent.
2
Air fi lters
CAUTION
Never use solvents or harsh chemicals. Also, do not wipe
z
plastic parts using very hot water.
(This may cause deformation or change in colour.)
Some metal edges and fi ns are sharp. Be careful when
z
you clean those parts. (Injury may result.)
Use a fi rm stool or ladder when cleaning an indoor unit
z
installed high locations.
Timer Remote Controller
Filter indicator
A
Filter reset button
„ After Cleaning
1. After the air fi lter is cleaned, reinstall it in its original
position.
Be sure to reinstall in reverse order.
2. [In the case of Timer Remote Controller]
Press the Filter reset button.
The (Filter) indicator on the display goes out.
[In the case of High-spec Wired Remote Controller]
Refer to the Operating Instructions attached to the
optional High-spec Wired Remote Controller.
High-spec Wired
Remote Controller
Filter indicator
20:30 (THU)