Table of Contents
Advertisement
WARNING!
Risk of short circuit and electric shock if the battery
charger has been damaged
-Do not use the battery charger if it has been dropped
or damaged.
WARNING!
Risk of Injury, Damage or Death
Improper routing of cord(s) may cause tripping,
entanglement or strangulation hazard that may result
in injury, damage or death.
-Ensure all cord(s) are routed and positioned properly
while charging.
-Avoid positioning cord(s) across areas of high
foot traffic (i.e. aisles, doorways, hallways, etc.)
while charging.
-Close supervision and attention is needed when
operating the wheelchair near children, pets or
people with physical/mental disabilities.
1. Perform one of the following
60101916-A
Charging NEW batteries—Ensure the mobility device
l
power is ON.
The wheelchair power must be on to ensure
that accurate battery charge levels display on
the remote. New batteries must be charged
fully. This includes on initial delivery and
after battery replacement. The Battery
Synchronization Procedure MUST be
performed within 24 hours of powering on
the wheelchair. The Battery Synchronization
Procedure can be found in the LiNX service
manual and must be performed by a
provider or qualified technician.
Charging existing batteries—Switch off the
l
mobility device.
7 Controls System
51
Advertisement
Table of Contents
