Vsub Voltage Check (Only Snc-Dm110); Procedure For Sy-358 Board Replacement; Re-Sticking Of Mac Address Label; Mac Address And Serial Number Writing - Sony SNC-DS10 Service Manual

2-3-5. VSUB Voltage Check
(only SNC-DM110)
1. Connect to this unit via browser and set "Light funnel
mode" to Always ON from the [Camera]-[Sense up]
tab in the setting window.
2. Shoot an arbitrary image and check that the image is
output correctly.
3. After the check, return "Light funnel mode" to the
original setting.
2-4. Procedure for SY-358 Board
Replacement
When replacing the SY-358 board, perform the following
procedure.
. Replace the old MAC address label with the new one.
(Section 2-4-1)
. Rewriting of MAC address and serial number
(Section 2-4-2)

2-4-1. Re-sticking of MAC Address Label

Replace the MAC address label on the bottom of the unit
with the new label supplied with the new SY-358 board.
2-12
2-4-2. MAC Address and Serial Number
Writing
Required equipment/Tools
. Personal computer (PC)
. LAN cable (cross cable)
n
When using a straight cable, connect the unit to the PC
through a HUB that is not connected to any other
networks.
. Software "RZ25MacSer.exe" for writing MAC address
and serial number: J-6433-410-B
n
Make sure to make a copy of the software
"RZ25MacSer.exe" for writing MAC address and serial
number in an arbitrary folder in the PC beforehand.
. Power supply for the unit: 24 V AC or 12 V DC
Connection diagram
Network port
Camera
LAN cable
(cross)
Personal computer
LAN cable
(straight)
Hub
LAN cable
(straight)
SNC-DS10/DM110