Connecting To An L1 Pro32 With A Submatch Cable; Autooff/Low-Power Standby - Bose Sub 1 Owner's Manual

Powered bass modules

Hide thumbs Also See for Sub 1:

Table of Contents

Setup

Connecting to an L1 Pro32 with a SubMatch Cable

Sub1/Sub2

Plug the SubMatch cable into the SubMatch Input on a Sub1/Sub2.

2. Plug the other end of the SubMatch cable into the SubMatch Output of the L1 Pro32.

3. Plug the power cord into the Power Input on the L1 Pro32.

4. Plug the other end of the power cord into a live electrical outlet.

Note: Do not power on the L1 Pro or the Sub until after you've connected your sources. See the L1 Pro32

owner's guide at PRO.BOSE.COM for more information about connecting sources to an L1 Pro32.

5. Press the Standby Button on the L1 Pro32 then press the Standby Button on the Sub. The LEDs will

illuminate white while the L1 Pro and Sub are on.

Note: Press and hold the Standby Button for 10 seconds to reset the Sub to factory settings.

When using two Subs via SubMatch cable connection, first turn on the Sub connected directly to the

L1 Pro32, then turn on the second Sub.

After four hours of no use, the Sub will enter AutoOff/Low-power Standby mode to save power. To wake the

Sub from AutoOff/Low-power Standby mode, press the Standby Button.

Note: Disable AutoOff/Low-power Standby mode by pressing and holding the Phase/Pattern Button and Line

Output EQ button simultaneously for 10 seconds. Enable AutoOff/Low-power Standby mode by repeating this

step. Disabling AutoOff/Low-power Standby mode will result in higher energy usage when the Sub is not in

use.

8 • English

L1 Pro32

Sub1/Sub2 Powered Bass Module • Owner's Guide

PRO.BOSE.COM

Table of Contents

Show Quick Links

Table of Contents

Sub 2