Advertisement
ETC Installation Guide
Access Interface
Interface LEDs
Power - The top blue LED lights when the device has power
Bluetooth - The bottom yellow LED lights and blinks when an active
Bluetooth radio is paired with a mobile device.
Note:
connection, see the EchoAccess App integrated help system.
Additional information on Echo systems is available at
etcconnect.com.
Install the wall plate
The wall plate is secured to the Interface with built-in magnets.
1.
Align the top of the wall plate to the Interface and angle the bottom
approximately 20 degrees.
2.
Hook the top of the wall plate to the tabs located on the Interface
electronics assembly. To ensure the wall plate is hooked properly on
the top hook, wiggle it slightly side to side.
3.
Swing the bottom of the wall plate down until the magnets engage.
4.
If the wall plate does not fully attach automatically, wiggle the bottom
of the plate until all of the magnets are seated properly to the Interface
and the plate is secure.
Note:
are misaligned in the mounting box, the wall play will not attach
properly. Loosen the screws that secure the station to the back box,
adjust each station to improve the alignment, secure the screws, and
then repeat the installation of the wall plate.
Access Interface
For more information on configuring devices via Bluetooth
If you are installing a multi-gang wall plate and the stations
Page 6 of 7
ETC
Advertisement
