Built-In Installation - Asko W6424 Operating Instructions Manual

Installation

Built-in installation

ASKO washers can be installed beneath a cabinet
or worktop with a height of 34½" (876 mm) or in
a closet. There must be a gap of about ½" (12
mm) all around the machine, including between
the rear edge of the machine's top panel and the
back wall. The opening width must be at least
24½" (622 mm). Space must also be available for
the inlet and drain hoses. See the illustration
below for measurements and positions. If the
washer is installed in a closet the door shall be
opend while the washer is running.
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
Customer Care Center 31
1-800-898-1879
www.askousa.com