Asko W640 Use And Care Manual page 27

Thermistor fault. Faulty thermistor, phone Ser-
vice.
Water inlet fault. Fault in the supply of water,
ensure:
- that the water tap is open.
- that the strainer in the water inlet connection
is not clogged.
1. Turn off the water tap.
2. Disconnect the hose.
3. Clean the strainer in the water inlet of the
machine.
4. Re-connect the hose.
5. Open the water tap.
6. Run the program again to check that the
fault is remedied.
Water outlet fault. Faulty pumping, check the
drain hose and the drain pump.
1. Straighten out any kinks in the drain hose.
2. Is there anything stuck in the drain hose
outlet? Clear the hose.
3. Is the drain pump blocked by foreign ob
jects? Clear the pump, see Chapter 12, Care
and cleaning.
Wash motor fault. Phone Service.
0000 flashes at the top right of the display. The
machine has failed to spin.
1. The machine incorporates an out-of-balance
detector, which reduces spin speed or prevents
spinning from starting if the load is very unba-
lanced. Turn the main switch,
it on again. Open the door and redistribute the
washing.
2. After correcting, run the program Spin.
If
display it is an indication that you have attemp-
ted to start a program with the door open. Clo-
se the door and try again.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered
for any reason, it can be restored to the initial
language again.
The available languages are Dansk, Deutsch,
English, Espanol, Français, Italiano, Nederlands,
Norsk, Portugués, Suomi and Svenska.
Proceed as follows to change the language:
Turn the main switch,
again. Press the
press the
mes must be completed within fifteen seconds.
Within three seconds after pressing
last time, step to the desired language using the
TEMPERATURE - CELSIUS OR FARENHEIT
If you want to change the temperature indica-
tion from Celsius (C) to Farenheit (F), proceed
as follows:
Turn the main switch,
again. Press the
press the
mes must be completed within fifteen seconds.
Within three seconds after pressing
off and turn
last time, use the
temperature indication.
flashes at the lower right corner of the
button five times, then
Enter
button five times. These ten ti-
P1
buttons.
button five times, then
Enter
button five times. These ten ti-
P2
off and turn it on
the
P1
off and turn it on
the
P2
buttons to select
27