Asko W640 Use And Care Manual page 14

1400 r/min.
For the programs Synthetic wash and Wool/
hand wash it is not possible to select higher
speed than 800 r/min.
With the
spin speed.
When you step to the desired speed it will be
shown at the upper right corner of the display
together with the
the highest speed the counter will start again at
the lowest speed.
STARTING THE WASHING PROGRAM
After completing your settings you can start the
washing program. Make certain the door is clo-
sed and then press the
The text
play indicates that the program has started. The
text field of the display shows the current stage
of the program while it is in progress.
The remaining washing time is shown at the
bottom right in the display within ten minutes
after the washing program starts.
When a program is choosen the washing time
is calculated. The calculated washing time can
vary from time to time due to the temperature
of incoming water.
Before the last rinse the remaining time is
recalculated and can then be decreased or in-
creased.
PUTTING IN MORE WASHING
If you decide to put in more washing after star-
ting the machine, hold the
sed for three seconds. Any water in the machine
14
button, step to the desired
symbol. After stepping to
button.
Start/Stop
at the lower edge of the dis-
button pres-
will be pumped out and the door will then open.
Put the extra washing in and close the door and
the washing program will start automatically
where it was interrupted.
CHANGING SETTINGS AFTER STARTING
It is possible to alter some settings after you
have started a washing program. However, to
make any alterations it is necessary that the
part of the program that you wish to alter has
not become activated. The settings that can be
altered are:
• E2: Eco/Efficiency - Can be altered before
cooling or pumping out of water from the main
wash begins.
• Super rinse - Can be altered before the final
rinse begins.
• Short spin - Can be altered before the final
spin begins.
• Spin - Can be altered before spinning begins.
• Temperature - Can be altered before the hea-
ting phase.
• Spin speed - Can be altered before the final
spin sequence begins.
As a precaution it is necessary that you hold
the button pressed for three seconds to
Menu
enable settings to be altered. You can then alter
the desired settings according to Temporary al-
terations or in the manner described in chapter
11, Making own washing programs.
CHANGING THE PROGRAM
Press the button for three seconds. The
Start/Stop
program will then be zero set and you can choose
a new program.