Trouble Shooting - Asko W640 Use And Care Manual

13 TROUBLE SHOOTING

DOOR WILL NOT OPEN
1. Check that the main switch is ON.
2. Is the power supply cut off? Check the fuses.
The door cannot be opened using the
button if the power supply is broken.
3. If the door cannot be opened in the normal
manner, proceed as follows to make an emer-
gency opening:
• Make certain that there is no water in the
machine. If there is water left in the machine
and you can not run the programme Drain, drain
off the water, eg, in a bowl, by pulling loose the
drain hose on the inside of the cover as illustra-
ted in chapter 12, Care and cleaning.
• Make certain that the main power switch is
OFF.
• Open the drain pump cover, down to the left.
Use the parti-
tion piece for li-
quid detergent,
as illustrated.
• Unscrew the screw holding the red plastic
handle in pla-
ce.
26
• Pull the handle and the door will open.
-
• Put the handle into its slot and screw it into
place. Close the drain pump cover.
If the door still cannot be opened in the nor-
mal way after this, phone for service.
MACHINE WILL NOT START
1. Is the door properly closed? Press it shut
firmly. The display flashes
if the door is not closed.
2. Is power cut off? Check the fuses.
3. Make certain that Delayed start is not acti-
vated.
FAULT INDICATIONS
Error messages appear in the display text field if
faults occur while a program is in progress. To
exit the error messages, switch the machine off
or change the program.
The error messages that can be displayed are:
Door lock fault. Phone Service.
Foaming. Run the Rinse program once. Check
dosing of detergent. Use low-lather detergent.
Over flow. Phone Service.
Pressure sensor fault. Phone Service.
Temperature stop fault. Faulty temperature
stop, phone Service.
down on the right