Zanussi ZTE 273 User Manual page 11

1. Open loading door
3. Use a damp hand
to clean the micro-
fine filter, which is
built into the lower
part of the loading
aperture.
Cleaning heat exchanger
Clean the condenser when light Condenseur
(Condenser) comes on.
The condenser is situated at the lower part of
the cabinet behind a small door.
www.zanussi.com
2. After a period of
time, a patina due to
detergent residue on
laundry forms on the
filters. Then clean the
filters with warm wa-
ter using a brush. Re-
move the filter from
the door pulling it out.
4. Remove fluff from
lint filter, preferably
using a damp hand
for this purpose.
Replace the filter.
1. To open the door,
push the catch as per
picture. During the
drying cycle or at the
end, it is normal for
water to be present
on the surface of the
condenser insertion.
3. Pull out the con-
denser unit holding it
at the handle .
Important! Do not use pointed objects or uten-
sils to clean the spaces between the plates, as
this could damage the condenser and make it
permeable. Re-fit the condenser, turn the red
stops upwards and close the door.
Important! Do not use this appliance if the
condenser has not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses in-
side the machine and is collected in a reservoir.
2. Turn the two red
stops downwards.
4. Clean it with a
brush and rinse it un-
der the shower if nec-
essary. Also clean the
outside, removing all
fluff. Clean the rubber
seal round the con-
denser cabinet and in
the inner part of the
small door with a
damp cloth.
11