Honda WDP30X Instructions Manual page 63

• CRANKSHAFT BALL BEARING FREE PLAY
1. Clean the bearing in solvent and dry it.
2. Spin the bearing by hand and check for play. Replace the
bearing if it is noisy or has excessive play.
2. GOVERNOR
DISASSEMBLY/ASSEMBLY
GOVERNOR WEIGHT (2)
ASSEMBLY:
Check that the weights move freely.
GOVERNOR WEIGHT PIN (2)
GOVERNOR WEIGHT HOLDER
ASSEMBLY:
• Before installation, check for
wear and damage of the gear.
• Be sure to install the governor
weight before installing the
crankshaft.
6 mm PLAIN WASHER
9-8
LOCK PIN
ASSEMBLY:
CLIP (2)
ASSEMBLY:
Install firmly into the shaft groove.
6 mm PLAIN WASHER
ASSEMBLY:
Install inside the case.
GOVERNOR SLIDER
ASSEMBLY:
Spread the governor weights to install the
slider; then check to be sure the slider
moves smoothly.
6 mm
THRUST WASHER
PLAY
AXIAL
Install the lock pin immediately after
installing the governor arm shaft, and
move the shaft over against the governor
slider.
The lock pin must be installed with the
straight side of the pin against the
groove in the shaft.
GOVERNOR ARM SHAFT
Date of Issue: April 2008
WDP30X
PLAY
RADIAL