Advertisement
6.3. Retrofitting from GD-1920C-BB (NavNet vx2) to TZT2BB
New – TZT2BB Configuration
Points:
(1) Install the new MCU-005 if a full keyboard operation is required, and add the POE injector to supply power to the MCU-005. Input NMEA0183 data to the NMEA2000 backbone via a converter such as the IF-NMEA2K2, or replace the NMEA0183
devices with NMEA2000 ones.
(2) Replace the Radar dome or open array with the latest DRS series.
(3) The BBFF1 and BBFF3 are NOT compatible with the NavNet TZtouch/2 network.
BBFF1
: Replace with the DFF1, BBDS1, or just connect the existing transducer to the built-in Fish Finder port of the TZT2BB.
BBFF3
: Replace with the DFF3.
(4) The FA-30 and FA-50 can be utilized.
(5) While NavNet vx2 MFDs support 10BASE-T for Ethernet communications, NavNet 3D, TZtouch, and TZtouch2 MFDs support 100BASE-TX. If the existing hub is compatible with 10BASE-T, replace it with the one compatible with
100BASE-TX or faster communications.
(6) Use the standard supplied power cable to the TZT2BB processor unit.
(7) If the monitor has the VGA (RGB) interface only, install a new monitor compatible with HDMI (or DVI-D for connection via DVI-HDMI adapter).
(8) Make sure that these monitors are compatible with the resolution of 1920×1080 (FHD), 1280×1024 (SVGA), and 1024×768 (XGA), which are output from the TZT2BB.
Previous – GD-1920C-BB Configuration
27
Advertisement
