Navnet TZtouch2 Series Manual page 24

6.1. Retrofitting from TZTBB (NavNet TZtouch) to TZT2BB
New – TZT2BB Configuration Previous – TZTBB Configuration
NavNet TZtouch (TZT9/14/BB) and TZtouch2 (TZTL12F/15F and TZT2BB) can share the common sensor data through Ethernet and NMEA2000, and the quantity of analog camera ports (RCA) is the same. While utilizing the existing devices, note
the following points in wiring.
Points:
(1) In addition to installing the processor unit MPU-004 and switch box PSD-003, the Ethernet cable to the processor should be replaced with the cable without a waterproof cap in order to fit it on the RJ45 port.
(2) Use the standard power cable to the TZT2BB processor unit.
(3) If the monitor has the DVI-D interface only, connect the DVI cable to the processor unit via a DVI-HDMI adapter to fit on the HDMI port.
(4) Make sure that these monitors are compatible with the resolution of 1920×1080 (FHD), 1280×1024 (SVGA), and 1024×768 (XGA), which are output from the TZT2BB.
24