Tps Ii™ Front Panel Features Diagram; Phantom Power +48V Switch; Phase Reverse Switch - Art TPS II User Manual

Tube preamp system

Hide thumbs Also See for TPS II:

Table of Contents

The TPS II can power any microphone needing +48 volts DC

Phantom power. Phantom power is supplied to pins 2 and 3 of the XLR

Input jack when this switch is depressed. The TPS II will slowly apply

and remove the +48volts, to prevent damage to microphones.

Be sure to turn down or mute the output of the TPS II when engaging

or disengaging Phantom power. Additionally, when disengaging, allow

30 to 45 seconds for the power to completely discharge. Most

microphones will make a sound like air leaking from a tire when

Phantom power is disconnected, but some can make some very nasty

low rumbles and whines as well.

Dynamic microphones should not be affected or damaged if they are

plugged into a line where Phantom power is present. However, if the

mic doesn't need it, do not use it. Some things are best left untested!

The Phase Reverse switch is provided to reverse the phase of the

signal. This switch works on Pins 2 and 3 of the XLR output jack and

TPS II™ Front Panel Features

- 7 -

Table of Contents

Show Quick Links

Table of Contents