Tires Inspection; Front Hub; Front Hub Removal; Front Hub Installation - Dinli DL702 Service Manual

WHEELS/TIRES
● Check the tire pressure using an air pressure gauge.
Tire Air Pressure (when cold)
Front: 35 kPa (5.0 psi)
Rear: 30 kPa (4.4 psi)
● Install the wheel (see Wheel Installation).
● Wipe off the soap and water solution on the tire and dry the tire
before operation.
Do not operate the vehicle with the water and soap still
around the tire beads. They will cause tire separation, and a
hazardous condition may result.
Tire Inspection
● Examine the tire for damage and wear.
○ If the tire is cut or cracked, replace it.
○ Lumps or high spots on the tread or sidewalls indicate internal
damage requiring tire replacement.
○ Remove any foreign objects from the tread. After removal, check
for leaks with a soap and water solution.
○ Check the shape of the tread knobs. If no vertical side is left on
the drive side of the knobs, replace the tire.

Front Hub

Front Hub Removal

● Remove the wheel (see Wheel Removal).
● Remove the cotter pin
● Remove the caliper by taking off the mounting bolts [A], and let
the caliper hang free.
● Remove the axle nut and pull off the front hub brake disc.
● Separate the brake disc from the front hub.

Front Hub Installation

● Grease::
Seal
Front Spindle
● Tighten:
Torque - Front Spindle Nut: 54 N-m (5.5 kgf-m, 40 ft-lb )
● Insert a new cotter pin and bend it over the nut
WARNING
【2-8】
A