Tires - Dinli DL-702 2008 Service Manual

Tires

Inspect every 1000 km (50 hours, 3 months)
Tire Tread Condition
● Operating the vehicle with excessively worn tires will decrease
riding stability and consequently invite a dangerous situation. It
is highly recommended to replace a tire when the remaining
depth of the tire tread reaches the following specification.
Tire Depth Gauge
Tire Tread Depth
Service Limit (Front)
Service Limit (Rear)
Tire Pressure
● If the tire pressure is too high or too low, steering will be
adversely affected and tire wear will increase. Therefore, maintain
the correct tire pressure for good roadability and a longer tire life.
Inflation Tire Pressure
Front
Rear
Vehicle Load Capacity Limit: 250 kg (551 lb)
To minimize the possibility of tire damage from over-inflation,
we strongly recommended that a manual type air pump be
used rather than a high pressure air compressor as found in
service stations. When filling air into the tires, never exceed
70kPa (0.7 kgf-cm , 10 psi).
2
The standard tire fitted on this vehicle is an AT25×8-12 for the
front and a AT25×10-12 for the rear. The use of tires other than
those specified may cause instability. It is highly recommended
to use the specified tires
PERIODIC MAINTENANCE
3.0 mm
3.0 mm
kPa Kgf/cm
2
35 0.35
35 0.35
CAUTION
CAUTION
【9-27】
psi
5.0
5.0
3.0 mm