Fahrenheit 28013 User Manual page 3

Preset temperature display: between 160°C-480°C-ig displays the
1.
temperature preset with the temperature set button.
Actual temperature display: Shows the actual temperature of the iron
2.
tip.
°C/°F switch button: The digital display shows the tip's temperature in
3.
°C or °F.
Power switch
4.
Temperature set button +/-: For setting the temperature of the iron tip
5.
(app. 160-480°C)
Iron holder
6.
Sponge
7.
Sponge-holder
8.
Iron
9.
ASSEMBLING AND SETTING UP THE SOLDERING STATION
IRON HOLDER
Warning!
The sponge is pressed, it expands when it is exposed to water. Before using
the device, wet the sponge, twist it to remove the unnecessary water, and
place it into the sponge holder. Using a dry sponge may damage the iron
tip and the sponge itself.
CONNECTION
Warning!
Make sure that the device is turned off when connecting the iron tip. Not
doing so may result in damage to the device. Only take it off the main unit
once the power has been turned off.
• Place the tip into the tip holder
• Connect it to the main unit.
• Make sure that the wall connector is grounded.
• Connect the power cable to the grounded wall connector.
USAGE
Turn the device on. Set the desired temperature with the temperature
set knob and after a short while the device is ready for use. Replace the
soldering tip into the holder when not in use.
USING AND MAINTAINING THE IRON TIP
THE TIP'S TEMPERATURE
High soldering temperatures may damage the tip. Use always with
the lowest available temperature that provides quality results. Better
quality soldering materials provide better quality results even at lower
temperatures. This protects the soldered materials from high temperature
damage as well.
User Manual
EN