Modal SKULPTsynth SE User Manual page 16

Settings
General
• Clock Source: Sets the clock source for the SKULPTsynth SE with the following available
options: Internal, MIDI, Sync-In, Auto. If 'Auto' is selected then the SKULPTsynth SE will
automatically use any detected clock source (prioritising Sync-In over MIDI) else it will use
the internal clock. Please note that if 'MIDI' or 'Sync-In' is selected whilst there is no MIDI
or Sync-In clock present then clocked-synced functions (sequencer, arpeggiator, delay FX,
LFOs) may not work correctly or at all.
This can be set from the panel by holding the PLAY button whilst powering on the device
and using the touch pads to select the source (1-4 = Internal, 5-8 = MIDI, 9-12 = Sync-In,
13-16 = Auto)
• Global Tune: Sets the global tuning of the SKULPTsynth SE with a range of +/- 1
semitone. You may need to adjust this if using the SKULPTsynth SE with other synthesisers
that are not tuned to the standard tuning (e.g. old analogue synthesisers).
• Touch Sensitivity: Allows you to change the sensitivity of touch pad 1. A device reboot
is required to apply any changes made to this setting.
30 31