Assembly Of The Upper Supports - boho office EASYDESK LINE Aassembly Instructions

Assembly of the upper supports

Place a slightly inclined upper support at the end of the crossbeam.
Press the plate carrier into position until a click is heard.
Make sure that the upper supports are correctly positioned and cannot be twisted
by the DF2 support.
Place the assembled DF2 frame in the correct position.
Use a tape measure to measure the central position of the DF2 frame on the
desktop.
c
A
B
a
A
c
Fix the DF2 frame to the desktop with 20 screws:
8 screws at the ends of the support (A)
Use one of these screws to fix the mains cable to the support with the cable clamp to
provide strain relief for the cable, see sketch 1.
12 screws in the crossbeam (B)
1
B
b
c
A
B
a
A
c
4