boho office EASYDESK LINE Aassembly Instructions page 10

Control panel information
Setting the correct table height - Switching between inches and centimetres
Setting the correct table height:
If the height shown on the display does not correspond to the actual height of the table,
it can be corrected.
Measure the height of the table from the floor to the desktop. Press and hold the "bell"
key and the Bluetooth® key for 5 seconds. When the display starts flashing, press the
panel up if the displayed number is too low or down if the displayed number is too high.
Switching between centimetres and inches:
You can switch between centimetres and inches by pressing and holding the "star" key
and the Bluetooth® key for 5 seconds. When the display starts flashing, press the panel
up or down and the unit changes.
How to connect to the app
Press and hold the Bluetooth® key for 2 seconds. The light strip starts flashing blue.
The display shows the table ID.
Open the app you downloaded earlier and connect to the table. To do this, find the cor-
responding ID from the "Tables nearby" list.
Follow the instructions in the app.
The table can neither be moved up nor down.
Possible problem: The control unit is not connected to the power supply.
Try the following/solution: Try connecting a lamp or similar device to the power supply
to check that the required supply voltage is available.
Possible problem: Are the plugs correctly plugged into the control unit or table leg?
Try the following: Check all connections.
Possible problem: Do cables, controls, control unit or deskframe legs
show visible damage?
Solution: Damaged parts must be replaced. Please contact us!
10