Support - Seeley MaglQtouch Installation And Owner's Manual

SUPPORT

Symptom
The MagIQtouch
Wireless Smart
Controller has no
display
The MagItouch
Wireless Smart
Controller states
'This Controller
has lost
Communication!'
The MagIQtouch
Wireless wall
controller will
not pair
The Installation
wizard states 'No
appliances found'
23 |
Cause
Batteries not fitted
Batteries not fitted
correctly
Batterries are low
Controller in sleep
mode
Wireless Smart
Controller out of range
Appliance connected
to Wireless receiver is
switched off
Batteries in controller
are low
Installation has been
powered up for longer
than 8 minutes after
'Pair' is pressed on
controller
The Wireless receiver
is not connected
2x MagIQtouch
Wireless controllers are
already paired
20m communications
cable supplied with kit
is broken or damaged
Wireless Smart
Controller out of range
to Wireless receiver
The wireless smart
controller has been
paired but the
installation has been
started after the initial 4
minutes of cycling the
power
Action
Remove battery cover and fit 4x AA
batteries
Ensure batteries are orientated as shown
inside battery cavity
Replace 4x AA batteries
Press the Home button to the right of the
screen
Check RF signal in 'SETTINGS'. Move
controller closer to Wireless receiver.
Check power to the installation.
Replace 4x AA batteries
Cycle the power to the installation to
initiate the 8 minute 'discovery mode' on
the wireless receiver and press 'PAIR' on
wireless smart controller
Ensure the Wireless is connected and
installed correctly in the installation circuit
Remove 1x Wireless controller from
'SERVICE' screen. Only a maximum of 2x
wireless Smart controllers can be paired
Replace cable
Move wireless receiver and Wireless
Smart controller closer together.
Cycle the power to the installation and
press 'RETRY' on the wireless controller