Conformity - ADS-tec IRF1000 Series Instruction Manual

IRF1000 series

2.8 Conformity

The manufacturer hereby declares that this device has been marked with the CE mark in accordance
with the basic requirements and other relevant conditions of the following European Directives:
2011/65/EU, RoHs Directive
•
• 2014/30/EU, EMC Directive
2014/53/EU, RED Directive
•
2014/35/EU, Low Voltage Directive
•
The following applies with respect to electromagnetic compatibility: The device is a Class A device
(industrial sector).
The EU conformity declaration is available for download at
https://www.ads-tec.de/en/support/download/industrial-it/ec-declaration.html.
Recommendation for use:
For full compliance with the EMC legislation, all components and cables used for
device connection must also be compliant with these requirements. It is therefore
necessary to employ BUS and LAN cables with shielded connectors and these must
be installed as per the instructions contained in the instruction manual.
Devices with FCC marking on the type plate:
Compliance with the requirements of the FCC (USA)
Class A digital device
This device has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when used in a commercial
environment. This device generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. Operation of this device in a residential area is
likely to cause harmful interference. In such a case, the user must correct the
interference at his own expense.
Compliance applies for models with a corresponding FCC marking on the type plate.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany
Instruction manual v1.3 9