Safety Instructions; Operating Location; Damage Due To Improper Use - ADS-tec IRF1000 Series Instruction Manual

IRF1000 series

3.1 Safety instructions

ATTENTION
To prevent damage to the device, all cable lines (power supply, interface cables) must
only be connected while the device is switched off.
ATTENTION
All installation work performed on the device must be performed only under safe, secure
and de-energised conditions.
Recommendation for use:
Always adhere to the safety measures applicable when handling components at
risk of being damaged by electrostatic discharges (EN 61340-5-1 / EN 61340-5-2).

3.2 Operating location

This device is designed for industrial use. Make certain that the specified environmental conditions are
maintained at all times. Use in non-specified environments, i.e., on board ships, in explosive
atmospheres or at extreme elevations, is prohibited. See also chapter 8 Technical data.
ATTENTION
Damage caused by condensation!
To prevent short circuits and malfunctions caused by the formation of water condensate,
the device may only be turned on after it has reached the specified ambient
temperature. This also applies if the device is exposed to extreme temperature
fluctuations.
Damage caused by heat!
 Do not expose the device to direct radiation by sunlight or any other light or heat
source!

3.3 Damage due to improper use

Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany
Instruction manual v1.3 11