Models; Mounting Instructions; Operating Instructions - Delta-q RQ Series User Manual

RQ Series Battery Chargers User Manual

MODELS

The RQ Series has several models:
Model
RQ0350-012
RQ0350-024
RQ0350-036
RQ0350-048
* Smaller pack sizes can be accommodated. Special testing or configuration may be required to ensure
efficiency legislation compliance. Contact Support at Delta-Q Technologies if charging smaller pack sizes.

MOUNTING INSTRUCTIONS

Robust mounting points are cast into the charger's aluminum enclosure. At each corner are 4.5mm x 8mm
diameter slots, arranged to allow ample tolerance when mating with standoffs or pre-drilled holes in a
machine. Use M4 screws of an appropriate length to secure the charger to the intended support.
If mounting the charger on a vehicle or machine frame that may be prone to flexing, it is recommended
to mount the charger using only three of the mounting points to prevent the charger case and internal
components from being subjected to undue stress and torsional loads.
Mount the charger securely using the mounting points.
•
• A bracket may need to be fabricated, particularly if there is insufficient cooling air flow.
Do not drill holes in the charger.
•

OPERATING INSTRUCTIONS

• On a 120V AC input, you can connect a maximum of three (3) chargers to a single 15A circuit.
• On a 240V AC input, you can connect a maximum of four (4) chargers to a single 10A circuit.
Page 7 of 12
Copyright © 2021 Delta-Q Technologies Corp
Maximum Voltage
18V
36V
60V
72V
Lead Acid
6 Cell 150* - 250 Ah
12 Cell 75* - 250 Ah
18 Cell 50* - 250 Ah
24 Cell 40* - 250 Ah
www.delta-q.com
Lithium-ion
3-5 Cells 150* - 250 Ah
6-10 Cells 75* - 250 Ah
9-16 Cells 50* - 250 Ah
12-20 Cells 40* - 250 Ah