Emc Declaration - Delta-q RQ Series User Manual

RQ Series Battery Chargers User Manual www.delta-q.com

EMC DECLARATION

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules for the United States and the ICES Regulations for Canada. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Class
A models of this equipment are available upon request.
Note: If a Delta-Q Technologies sealed cord with an over-molded ferrite bead is not used, a clamp-on
bead (LAIRD 28A0807-0A2 ) can be added to the AC cord to ensure Class B compliance. It should be
positioned approximately the same distance from the charger as the beads on the DC and signal cables.
Page 6 of 12
Copyright © 2021 Delta-Q Technologies Corp