Advertisement
PRODUCT
SETUP
HARDWARE SETUP
Ensure that your DWR-M920 Mobile Router is powered off before performing the steps below.
1. Insert a standard USIM card into the SIM card slot located on the backside of the router
with the gold contacts facing downward.
2. Insert the Ethernet cable into the LAN Port 1 on the back panel of the DWR-M920 Mobile Router,
and the other end into an Ethernet port on a computer to configure the unit.
3. Connect the power adapter to the socket on the back panel of your DWR-M920 Mobile Router and
plug the other end of the power adapter into a wall outlet or power strip.
a. Turn ON the router. The Power LED
b. After a few moments, if a connection has been established, the following LEDs will turn
solid blue: Power, LAN 1-3 (depending on which port your Ethernet cable has been
connected to), Wi-Fi, LTE and WAN (if connection is used).
c. The initialization process takes about 45 seconds to a minute.
Note:
The 4G connection can also be used as a backup WAN. Once a backup is configured.
Note:
The DWR-M920 Mobile Router LAN Ports are "Auto-MDI/MDIX." Therefore, patch or
crossover Ethernet cables can be used.
ADVANCED SETUP (ACCESS VIA IP ADDRESS)
Open a browser window and enter the below IP address into the browser address field.
Log in using the username and password below.
IP ADDRESS:
DWR-M920
will light up to indicate that power is being supplied to the router.
http://192.168.0.1
USERNAME:
admin
PASSWORD:
(as printed on the
device label)
Wi-Fi NAME:
dlink-M920-2.4G-xxxx
(as printed on the
PASSWORD:
device label)
3
Advertisement
