Advertisement
Toner that doesn't cost the earth
Printed on recycled paper, using refilled cartridges
Remove only the white reset gear.
Set the reset gear spring as shown.
Note the red arrows show the exact position that the
spring fits.
Replace the gears as shown opposite.
Note that the gear teeth are not meshed when set,
which is how it should be.
The gear is spring loaded and will turn when driven by
the printer.
Note the position of the straight edge (shown in
yellow) of the agitator gear.
This position is required to properly reset the
printer. If you do not replicate this position it
will not reset !
With the gear set in the correct position, re-install the
gear cover plate and replace the two screws as shown
opposite.
© Zinetic.co.uk. All Rights Reserved
Advertisement
