Changing The Opening Direction Of The Doors - Whirlpool ADN350S Instruction Manual/Product Information Sheet

THE THE APPLIANCE COMPARTMENT DEFROSTS AUTOMATICALLY. Drops of ice that form on
the back wall of the refrigerator compartment thaw during the time the compressor is not
working and the thaw water runs down the thaw water runoff channel to the tray on top of the
compressor, where it evaporates.
REGULARLY CLEAN THE APPLIANCE.
Remember that before cleaning the back part of the appliance body you must
disconnect the appliance from the electrical energy supply
socket by pulling the plug out of the electricity outlet.
Protect the appliance inner surfaces and plastic parts from fats, acids and
•
sauces. In case of accidental spills – immediately clean with warm soapy
water or dishwashing detergent. Wipe dry inner and outer surfaces.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A SPECIAL
•
CLEANER FOR THAT PURPOSE.
At least once a year clean dust away from the back part of the appliance
•
body and the compressor. A soft brush, electrostatic cloth or vacuum cleaner may be used for
cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for cleaning
•
the appliance inner and outer surfaces. DO NOT use for cleaning cloths or sponges that have
coarse surfaces intended for scrubbing. Outer of the doors – glass – clean with agents
intended for glass cleaning.
IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD, LEAVE ITS
•
DOORS OPEN.

CHANGING THE OPENING DIRECTION OF THE DOORS

It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the appliance horizontally.
Do the actions below in the order they are listed:
WARNING! Turn off the appliance and pull the plug out of the electricity supply
socket.
For AND 350S (see page 3, fig. 7):
1. Remove the lower bracket 8 together with washers 6 on the axle and the plastic gasket 5, the
lower bracket 11 and the lower cover 10. Remove the refrigerator door.
2. Unscrew axle counterclockwise. Remove together with nut 1 and washers 3.
3. On the opposite side screw in the axle clockwise together with nut 1 and washers 3.
4. Insert the refrigerator door into the screwed-in axle 2.
5. Screw the lower cover 10 and the lower bracket 8 together with washers 6 onto the axle and
the plastic gasket 5 in place of the bracket 11. Screw the bracket 11 in place of the bracket 8.
6. Remove handle 12 and attach it on the opposite side. Plug up the remaining holes on the
right side with lids 13 in the sachet inside the refrigerator.
For AND 480S (see page 3, fig. 8):
1. Turn off the appliance and pull the plug out of the electricity supply socket.
2. Unscrew three screws 2 on the upper door suspension bracket 1, unscrew the axle 3 and turn
it towards the opposite side of the bracket.
3. Remove the door 4 by lifting it up;
DEFROSTING, CLEANING AND CARE
9