Changing The Opening Direction Of The Doors - Whirlpool ADN203 C Instruction Manual

Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In
•
case of accidental spills – immediately clean with warm soapy water or dishwashing
detergent. Wipe dry.
Clean the appliance inner surfaces with warm soapy water. Dishwashing detergent
•
may also be used. Wipe dry inner and outer surfaces.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A
•
SPECIAL CLEANER FOR THAT PURPOSE (see fig.).
At least once a year clean dust away from the back part of the
•
appliance body and the compressor. A soft brush, electrostatic cloth
or vacuum cleaner may be used for cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or
•
benzene for cleaning the appliance inner and outer surfaces. DO NOT
use for cleaning cloths or sponges that have coarse surfaces intended
for scrubbing. Outer of the doors – glass – clean with agents intended for glass
cleaning.
IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD,
•
LEAVE ITS DOORS OPEN.
Remarks on the appliance operating noise. As the appliance operates and
goes through the freezing cycle, various noises will be emitted. This is normal
and is not a sign of any malfunction.
As the refrigerant circulates around the refrigeration system, it causes sounds like
•
murmuring, bubbling, or rustling.
Louder sounds like popping or clicking may be heard for a short time as the
•
refrigerator compressor switches on.

CHANGING THE OPENING DIRECTION OF THE DOORS

It is recommended that changing the opening direction of the doors should be done
with a helper. When changing the opening direction of the doors YOU CAN NOT lay the
refrigerator horizontally!
Do the actions below in the order they are listed (see fig. 3, page 2):
1. Turn off the appliance and pull the plug out of the electricity supply
socket.
2. Remove the two screws (8) and separate the bottom bracket (10) together with the
washers and gaskets (9) on the small axle.
3. Remove the two screws (7) and separate the bracket (5) and the gasket (6).
4. Separate the door (4).
5. Remove the 4 screws (1) at the top of the advertising panel, separate the top of the
advertising panel (11), remove the front part of the advertising panel (12), and
then remove 4 screws (13) and separate the advertising panel; then loosen the 2
screws (14) and transfer the upper bracket (15) to the other side. Assemble the
advertising panel in reverse order.
6. Turn the door 180°, insert the upper axle and mount the door on it.
7. Remove the mounting screws (2) from the door, separate the handle (3) and attach
it by screwing the screws into the holes on same side.
8