Roadrunner - Colorado time systems MS-0149 Installation And User Manual

RoadRunner

The RoadRunner PCIF must be on the same channel as the wireless scoreboard
adapter inside the scoreboard. The default factory setting of the wireless scoreboard
adapter inside the scoreboard is Channel 7
When the scoreboard is turned on, it displays an initialization routine which includes the
scoreboard's channel, PAN and address, and then the channel of the wireless
scoreboard adapter inside the scoreboard. This display is described in more detail in the
Scoreboard Power On Routine on page 2.
Note the channel displayed under Lane and Place during initialization, and follow
instructions in the RoadRunner user guide to set the PCIF to the same channel through
the RoadRunner software. You can then follow the user instructions to wirelessly change
the channel of the scoreboard adapter inside the scoreboard if desired.
Synchronizing Time of Day
To set multiple scoreboards to the same time, they must be set to the same channel and
PAN (See page 3, 5, or 8 for your application).
Designating Leader/Follower with WTTC, WA-3 or WA-2
1. Connect a WTTC, WA-3 or WA-2 to your computer using a USB cable.
2. Make sure the Channel and PAN are set to match your scoreboard.
a. WA-3 or WA-2: use the dipswitches on the device
b. WTTC: use the on-screen menu. After checking /setting the Channel and
PAN and saving any changes, turn the unit off and then on again and
leave it at the Sport Selection menu.
3. From your computer, open the MultiSport Firmware Reprogramming tool.
a. If you do not have this tool, download it from the CTS website at
https://www.coloradotime.com/support-overview/installation-methods.
Choose the MultiSport tab and download MultiSport Display Firmware.
4. Click "Scan for Devices"
5. Select your attached WTTC or WA-3/WA-2 (WA-3 will be listed as WA2)
6. Click "Get Sub-Devices"
7. Select the scoreboard you wish to set as leader.
a. Click the "Enable (as Leader)" button at the bottom of the screen.
b. The scoreboard will display Lead for a few seconds
8. One by one, select the scoreboard you wish to set as follower.
a. Click the "Enable (as Follower)" button at the bottom of the screen.
b. The scoreboard will display FOLL for a few seconds
9. Close the software and disconnect you WTTC, WA-3 or WA-2.
Setting Time of Day and Changing Channel with Wireless Tabletop
Controller (WTTC)
For tabletop controller (WTTC), enter any sport and press the Menu button. Select "Set
Time". Time of Day from WTTC will override the time on the leader and all follower
clocks and scoreboards.
To change the channel and PAN, select "Scoreboard Options" in the Menu.
When finished, press Clear to exit the menu.
www.coloradotime.com
7