CONTENTS Page number Specifications...………………………………………………….…….………3 Unpacking and Inspection ……..………………………………….….………4 Description...…………………………………………………….….………...4 Theory of Operation…………………………………………….….…………4 Setup Instructions……………………………………………….….…………5 Typical System Set-Up………………………………………….……………6 Maintenance and Cleaning.…………………………………….………..…7-8 Spare Parts……………………………………………………….………..9-10 Repair Kits……………………………………………………….………….11 Accessories…………...…………………….……………….….…………...12 Troubleshooting…….………………………..………….…….…………..13 Warranty…….……………………………….…………….….…………….14...
Manufacturer be liable for consequential or incidental damages. A return Air Inlet Port 10-32 UNF 10-32 UNF authorization is required from Techcon Systems prior to shipping a defective unit Auxiliary Air Inlet to the factory. 10-32 UNF 10-32 UNF Port...
Operating pressure too low (4.8bar) DESCRIPTION No fluid The TS5322 Series Mini Spool Valve is designed to dispense medium to high flow viscosity fluids with very precise deposits, over a wide range of shot and bead Dispense tip clogged or Replace tip sizes.
STANDARD ACCESSORIES SET-UP INSTRUCTIONS 1. Connect the fluid reservoir feed tube (1) to the valve inlet port (2). PART NUMBER DESCRIPTION 2. Connect the valve air hose (3) to the valve controller or other pneumatic device, TSD700-9 Oiler Cup, 90 Degrees which is used to control the valve.
PART NUMBER DESCRIPTION TSD931-57 Luer Lock Adaptor 5320-000-001 Outlet Block For TS5322 NOTE: Avoid using sharp probes for cleaning. Any nicks or scratches on the 5320D-000-001 Outlet Block For TS5322D seal or the surfaces of the spool assembly may cause leakage...
Page 8
17. Insert o-ring (10) into outlet block (11). SPARE PARTS 18. Re-install outlet block (11) to fluid housing (6). Valve Rear Section 19. Lubricate o-ring (17) with Bimba HT-99, or equivalent. Recommended lubricant: 20. Thread the air cylinder/spool assembly into fluid housing/outlet block assembly.