Advertisement
Quick Links
Advertisement
Related Manuals for Miniature Scenery TWISTED STEAMPUNK CATCHWAGON
Summary of Contents for Miniature Scenery TWISTED STEAMPUNK CATCHWAGON
- Page 1 TWISTED STEAMPUNK CATCHW AGON...
- Page 2 Instructions TWISTED CATCHW AGON Preparation You will need: - Cutting mat or something to protect your table. General Process - PVA/Wood glue or superglue if you prefer. - Clear plenty of table space, you will need it. - Small file or sand paper. - Parts should remove easily from the board by pressing through and - Small blade / hobby knife popping them out.
-
Page 3: Important Note
Important Note: Through- out the construction of this kit parts such as the body of the horse will need to be aligned carefully. Use the holes provid- ed to insert (DO NOT GLUE) some of the provided 2mm tub- ing to help with this. The in- structions will tell you when it’s time to glue the tubing in. - Page 4 Alignment point Cut tubing to 10mm length and glue centrally.
- Page 5 Hole should be clear !
- Page 6 Hole should be clear !
- Page 7 Hole should be clear !
- Page 9 WELCOME to the TINIEST BITS in the kit! They’re especially fiddly.
- Page 12 Holes should be clear !
- Page 15 Cut tubing to 40mm length and glue centrally.
- Page 16 Tubing should protrude by approximately 2mm. Cut tubing to 18mm length and glue Cut tubing to 40mm length and glue centrally.
- Page 20 4mm dowel Cut tubing to 8mm length and glue. Cut a small notch to better represent a whistle.
- Page 23 Cut tubing to 40mm length and glue centrally.
Need help?
Do you have a question about the TWISTED STEAMPUNK CATCHWAGON and is the answer not in the manual?
Questions and answers