Fault Finding - Gardeo GCBE18VCR-LI20L Original Instructions Manual

FAULT FINDING

The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove battery before investigating fault
Symptom
Can not fit Guard over
cutting disc
Machine fails to operate
Machine functions
intermittently
Excessive vibration/
noise
Cutting time low on one
battery charge
Blade will not move
Machine is not cutting
No charging procedure
possible due to defective
battery
The LED indicator does not light
up after plugging the mains plug
into the socket
Possible Cause
Incorrect assembly
Battery discharged
Machines internal wiring
damaged
On/Off switch defective
Machine fault
Blade broken
Battery not used for long period
or initial usage
Grass too high
Battery worn out
Battery discharged
Machine fault
Blade broken
Battery not fully charged
Grass entangled around cutting
disc
The battery temperature is not
within the allowable temperature
range
The contacts of the battery are
contaminated
The battery is defective, due to a
disconnection
in the battery (individual cells)
The charger plug is not inserted
(properly)
Socket, cable or charger are
defective
Made in China
Remedy
Remove cutting disc and fit guard,
see also Product assembly
Recharge battery, see also
Charging advice
Contact Service Agent
Contact Service Agent
Contact Service Agent
Replace blade
Fully charge battery, see also
charging advice
Cut in stages
Replace the battery
Recharge battery, see also
Charging advice
Contact Service Agent
Replace blade
Recharge battery, see also
Charging advice
Remove grass
Get the battery temperature within
the allowable temperature range (0
° C to 45 ° C) either by cooling down
or warming up. As soon as the
battery temperature is within the
allowable temperature
range again, the battery charger
automatically switches to rapid
charging
Corrective measure: Clean the
contacts (e. g. by inserting and
removing the battery several times)
or replace the battery, as required
Replace the battery
Insert the plug (fully) into the socket
Check the mains voltage and if
necessary,
have the battery charger
checked by service agent.
2013
36