SwitchDoc Labs WeatherRack2 Installation Manual page 9

Figure8
Channel Number: The FT-020T supports up to eight transmitters. To set each channel number (the default is
Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
Temperature Units of Measure: To change the transmitter display units of measure (°F vs. °C), change Dip
Switch 4, as referenced in Table 1.
DIP SWITCH
1
DOWN
DOWN
DOWN
DOWN
UP
UP
UP
UP
---
---
Table 1
Insert two AAA batteries.
After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and then flash once per
60 seconds thereafter. Each time it flashes, the sensor is transmitting data. The unit will always transmit the
data in °F but the SwitchDoc Labs software always reports in metric units (°C).
Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on the display, as
shown in Figure 9.
13 Page
Version 1.3 October 2020
2 3
DOWN DOWN
DOWN UP
UP DOWN
UP UP
DOWN DOWN
DOWN UP
UP DOWN
UP UP
--- ---
--- ---
FUNCTION
4
--- Channel 1
--- Channel 2
--- Channel 3
--- Channel 4
--- Channel 5
--- Channel 6
--- Channel 7
--- Channel 8
DOWN °F
UP °C