Summary of Contents for SwitchDoc Labs WeatherSense Raspberry Pi WeatherRack2 Kit
Page 1
Raspberry Pi WeatherRack2 Kit November 2020 Version 1.1 Page Version 1.1 November 2020...
Page 2
Notes on Radio Reception ............................ 10 Disclaimer ................................11 Introduction Thank you for your purchase of the SwitchDoc Labs Raspberry Pi Kit for the WeatherSense WeatherRack2. The following user guide provides step by step instructions for installation, operation and troubleshooting. Page...
Page 3
First Step Assemble your WeatherRack2 and Indoor T/H Sensor and put batteries in the units. Follow the instructions in WeatherRack2 Technical Specification and Assembly manual. Parts List NOTE: A Raspberry Pi Board is NOT included in this Kit Part A - USB Software Defined Radio (SDR) Part B –...
Page 4
Step 3 – Plug the USB on the SDR (Part A) into any USB slot on your Raspberry Pi. Installing Software and Testing Your Kit Set up your Raspberry Pi using your SD Card or the SDL SDCard and either use a monitor, ssh into the Raspberry Pi or use VNC.
Page 5
"mic" : "CRC"} WeatherSense Indoor T/H F016TH Found This is the raw data: {"time" : "2020-11-08 15:31:10", "model" : "SwitchDoc Labs F016TH Thermo- Hygrometer", "device" : 56, "modelnumber" : 5, "channel" : 2, "battery" : "OK", "temperature_F" : 73.300, "humidity" : 27, "mic" : "CRC"} {"time"...
Page 7
90-100% Disclaimer SwitchDoc Labs, LLC takes no responsibility for any physical injuries and possession loss caused by those reasons which are not related to product quality, such as operating without following the operating manual and cautions, natural disasters, or force majeure.
Need help?
Do you have a question about the WeatherSense Raspberry Pi WeatherRack2 Kit and is the answer not in the manual?
Questions and answers