Table of Contents
Advertisement
6.3 MODULE 3 - D
FRONT PANEL DISPLAY SELECT ENABLE (SEL)
SEL Enb
yES
yES
The
selection allows the
yES
displays.
FRONT PANEL COUNTER RESET ENABLE (RST)
RSt Enb
YES
The
selection allows the
RST
yES
shaded selections are only active when Counter B is enabled (Dual Count mode
or batch counter).
DISPLAY SCROLL ENABLE
d-ScroLL
yES
NO
The
selection allows the display to automatically scroll through the
yES
enabled displays. Each display is shown for 4 seconds.
DISPLAY COLOR (BACKLIGHT UNIT ONLY)
d-COLOr
rEd
rEd
Enter the desired display color, red or green. This parameter is active for
backlight units only.
DISPLAY INTENSITY LEVEL (BACKLIGHT UNIT ONLY)
d-LEVEL
1
to
5
Enter the desired Display Intensity Level (1-5). The display will actively dim
or brighten as levels are changed. This parameter is active for backlight units only.
ISPLAY AND
PARAMETER MENU
NO
button to toggle through the enabled
SEL
yES
NO
both A-b
NO
Count A
dSPLAy
Count b
button to reset the selected counter(s). The
NO
6rn
5
F
P
K
RONT
ANEL
P
ARAMETERS
PROGRAMMING SECURITY CODE
Pro CodE
000
The Security Code determines the programming mode and the accessibility
of programming parameters. This code can be used along with the Program
Mode Lock-out (
) in the User Input Function parameter (Module 1).
Pro Loc
Two programming modes are available. Full Programming mode allows all
parameters to be viewed and modified. Quick Programming mode permits only
the setpoint output time-out and counter load values (when applicable) to be
modified, but allows direct access to these values without having to enter Full
Programming mode.
Programming a Security Code other than 0, requires this code to be entered
at the
prompt in order to access Full Programming mode. Depending
Pro CodE
on the code value, Quick Programming may be accessible before the
prompt appears (see chart).
USER INPUT
USER INPUT
SECURITY
FUNCTION
STATE
CODE
1-99
______
not
Pro Loc
100-999
1-99
Active
Pro Loc
100-999
Not Active
0-999
* Entering Code 222 allows access regardless of security code.
SOFTWARE VERSION DISPLAY
CodE UEr
NO
Select
to momentarily display the meter software version before advancing
YES
to the next parameter. The software version is also displayed at power-up.
LOAD FACTORY DEFAULT SETTINGS
FACt SEt
MO
The
selection will return the meter to the factory default settings. The
yES
meter will display
and then return to
rESEt
been changed.
10
EY
(
3-dSPLAY
0
to
999
MODE WHEN "SEL"
FULL PROGRAMMING
KEY IS PRESSED
MODE ACCESS
0
Full Programming
Immediate Access
After Quick Programming
Quick
with correct code entry
Programming
at
Pro CodE
With correct code entry
prompt
Pro CodE
at
Pro CodE
Programming
0
No Access
Lock
Quick
No Access
Programming
With correct code entry
Pro CodE
prompt
at
Pro CodE
Full Programming
Immediate Access
NO
yES
NO
yES
, at which time all settings have
Pro
)
Pro CodE
prompt *
prompt *
prompt *
Advertisement
Table of Contents
