Operating Instructions; Hydraulic Oil Recommendation; Engine Oil Recommendations; Operating The Log Splitter - Oregon OR25TBS-1 Original Instruction Manual

Operating Instructions

Operating Instructions
WARNING: Read and thoroughly understand all
instructions in this manual and on safety decals before
assembling or operating this log splitter. Failure to do
so may cause serious injury or death. Do not allow
anyone to operate this log splitter who has not read
this manual. As with all power equipment, a log splitter
can be dangerous if assembled or used improperly. Do
not operate this log splitter if you have any questions
concerning safe operation. To get answers to any
questions, call our technical support department at
1-800-525-8322.
NOTE: This log splitter does NOT include hydraulic oil
or engine oil . Follow the instructions below for filling the
hydraulic tank . Refer to the engine owner's manual for
information on adding oil .
CAUTION: Do not start or run the engine before adding
oil in the hydraulic reservoir and oil in the engine.

Hydraulic Oil Recommendation

STEP 1: The hydraulic reservoir must be filled with
oil before operation . AW22 or AW32 hydraulic oil
is recommended when oil is needed . Automatic
transmission fluid can be substituted and should be used
instead of hydraulic oil when temperatures are below
32°F . Use only clean oil and take care to prevent dirt from
entering the hydraulic reservoir . Fill the hydraulic tank
with enough hydraulic fluid to register between the upper
and lower marks on the dipstick .
STEP 2: After the hydraulic reservoir and the engine
crankcase are filled with the recommended oil and
hydraulic fluid, fill the engine with fuel and start . With the
engine running at full speed, move the hydraulic valve
lever toward the foot plate until the ram stops, then push
the valve lever in the opposite direction and release .
The Ram will return to the start position . Repeat this
procedure several times to fill the ram and expel the air .
Note:
• Erratic movement of the ram indicates that there is still
air in the system .
• Hydraulic pump will prime itself .
After cycling the hydraulic ram several times, shut off the
motor and top off the hydraulic fluid, and look for leaks .
24

Engine Oil Recommendations

For engine oil recommendations and engine starting
instructions, please see engine owner's manual for
further information.

Operating the Log Splitter

Before operating the log splitter, do the following:
For the wood, make sure the wood is at the correct
length, no longer than 25 .5" . If splitting in the horizontal
position, do not split logs over 100 lbs .
Select a level splitting area, away from wet ground and
slippery slopes .
Make sure you have enough light, never operate the
splitter in the dark .

Log Splitter Setup

Move log splitter to selected area mentioned above .
Disengage the log splitter from towing vehicle by pulling
on the locking lever from the 2" ball coupler and lower the
ground or jack stand . Then, disconnect the safety chains .