Installation; Mounting The Spa3; Fitting Mounting Brackets (Optional) - Renishaw SPA3 Installation Manual

SPA3 installation guide
www.renishaw.com

Installation

Mounting the SPA3

The SPA3 unit draws air from the right hand side when viewed from the front and expels air out of the left hand side. A minimum clearance
gap of 10 mm is necessary between the sides of the unit and any potential obstruction. The dimensions shown on the above drawing are in
mm (in).

Fitting mounting brackets (optional)

NOTE: The screws supplied with this kit are M5 × 6 mm countersink type.
Issued 11 2020
15