Download Print this page

Advertisement

Quick Links

General Instructions
02SNO0705-V4-PEFC
7x5 Snowdrop Playhouse
BEFORE YOU START PLEASE THE READ INSTRUCTIONS CAREFULLY
- Check the pack and make sure you have all the parts listed in the parts list provided.
- When you are ready to start, make sure you have the right tools at hand (not supplied) including a
Phillips screwdriver, Flathead screwdriver, Stanley knife, Wood saw, Step ladder, Hammer, Spirit level and
a Drill with 2mm bit.
- Ensure there is plenty of space and a clean dry area for assembly.
- Ensure you have enough time to build the product to ensure the building is water tight.
TIMBER
As with all natural materials, timber can be a ected during various weather conditions. For the duration
of heavy or extended periods of rain, swelling of the wood panels may occur. Warping of the wood may
also occur during excessive dry spells due natural processes. Unfortunately, these processes cannot be
avoided but can be helped. It is suggested that the outdoor building is sprayed with water during
extended periods of hot weather and sheltered as much as possible during rain or snow.
Our buildings are pre treated with a water based treatment**; this only helps to prevent discolouration
whilst in stock. To validate your guarantee and ensure longevity of the product, it is ESSENTIAL the
building is treated with a suitable preservative in accordance with the manufacturers recommendations.
Care must be taken to ensure the product is placed on a suitable base.
We recommended using a suitable protection for your playhouse. As the product is destined for use by
children, a water based treatment that is EN71 tested for children is ESSENTIAL.
We also recommend treating the building prior to construction.
POSITIONING YOUR PLAYHOUSE
When thinking about where the building and base is going to be constructed:
Ensure that there will be access to all sides for maintenance work and annual treatment.
We recommend a minimum space of 2m around a playhouse, away from any structure or obstructions
such as fences, garages, houses, overhanging branches, washing lines or electrical wires.
It is recommended that the position of the Playhouse, Slide and Swing is not in direct sunlight.
Activity toys such as swings and slides for towers shall not be installed over concrete, asphalt or
any hard surface.
BUILDING A BASE
Ensure the base is level and is built on rm ground, to prevent distortion, checking with a spirit level.
Refer to diagrams for the base dimensions. The base should be slightly smaller than the external
measurement of the building, i.e. The cladding should overlap the base, creating a run o for water. It is
also recommended that the oor be at least 25mm above the surrounding ground level to avoid
ooding.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
- Wooden base.
WARNING: Only for domestic use
Not suitable for children under 36 months due to
small parts and danger of falling from heights.
To be used under direct supervision of an adult
Please retain product label and instructions for future reference
WARNING
ONLY SUITABLE FOR DOMESTIC USE.
!
TO BE USED UNDER DIRECT SUPERVISION OF AN ADULT.
THIS PRODUCT SHOULD NOT BE MODIFIED IN ANY WAY. ANY MODIFICATIONS SHOULD BE
DETERMINED BY THE MANUFACTURER AND CARRIED OUT ACCORDING TO THE INSTRUCTIONS.
DO NOT ALLOW YOUR CHILD TO PLAY WITH ANY COMPONENT PARTS PRIOR TO ASSEMBLY.
MAX AGE OF 14 YEARS.
THIS TOY IS FOR OUTDOOR USE ONLY.
USE A WATER BASED TREATMENT THAT IS EN71 TESTED
CAUTION
Wood is a natural product and can change post manufacture. So despite every e ort being
made to ensure the material used are cut and machined to a clean and smooth nish, care
must be taken when handling the product and preparing for use by your child.
Any areas of concern, in the play areas, can be rubbed over with sandpaper to achieve a
smoother nish. Alternatively, call the customer service department who will be happy to
arrange replacement panels/parts.
All buildings should be erected by
x2
atleast two adults.
DO NOT ALLOW
CHILDREN TO ASSIST.
To prevent damage during
assembly, you MUST pilot
drill all screw holes and
ensure all screw heads are
2mm Drill bit
countersunk.
12mm CSK
Whilst all products manufactured are made to the highest standards of Safety and in the case of childrens products
independently tested to EN71, we cannot accept responsibility for your safety whilst erecting this product.
**Protim Aquatan T
Your building has been treated with Aquatan.
Aquatan is a water-based concentrate which is diluted with water, the building as been treated by the correct application of
Aquatan solution and then allowed to dry.
Aquatan is a decorative nish to colour the wood, which is applied industrially to timber fence panels and garden buildings.
Aquatan undiluted contains: boric acid, sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl sulphosuccinat and
alcohols: 2, 4, 6-trichlorophenol.
In all instances for assistance with your product, please contact customer care on :
01636 880514 or customerservice@merciagp.co.uk
Mercia Garden Products Limited,
Sutton On Trent,
Newark,
Nottinghamshire,
NG23 6QN
Winter = High Moisture = Expansion
Summer = Low Moisture = Contraction
For ease of assembly, you will
need a tape measure to check
dimensions of components.
www.merciagardenproducts.co.uk
P1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Snowdrop and is the answer not in the manual?

Questions and answers

Summary of Contents for Mercia Garden Products Snowdrop

  • Page 1 Not suitable for children under 36 months due to ONLY SUITABLE FOR DOMESTIC USE. small parts and danger of falling from heights. 7x5 Snowdrop Playhouse • TO BE USED UNDER DIRECT SUPERVISION OF AN ADULT. To be used under direct supervision of an adult •...
  • Page 2 02SNO0705-V4-PEFC Please retain product label and instructions for future reference Look for the symbols and follow the safety guidlines below. Ensure screw heads are sub ush and Ensure the screws are 12mm gap sand down any xed squarely and do surrounding the splinters created.
  • Page 3 Please retain product label and instructions for future reference Bunk Floor Block A QTY x2 F2770-666mm Pre Assembly Bunk Floor Block B F2744-474mm Before assembling remove the transportation blocks from the bottom of each panel. Bunk Floor Block C QTY x2 F2744-343mm Take care removing the blocks as to not damage the panels.
  • Page 4 Please retain product label and instructions for future reference Please retain product label and instructions for future reference Step 1 Step 2 Parts needed - x3 & Parts needed - & & Pre drill Pre drill hole hole Lay the Door Gable (No. 1) with To x the Windows into the *Please note that the door can be hung the boards facing up on a at surface.
  • Page 5 Please retain product label and instructions for future reference Step 4 Step 6 Parts needed - & Parts needed - & Pre drill Pre drill hole hole Fix the corners of the Plain Gable Fix the Bunk Floor Support Bar (No.
  • Page 6 Please retain product label and instructions for future reference Step 8 Step 10 Parts needed - & Parts needed - & Pre drill Pre drill hole hole Fix the Bunk Floor Block D (No. 24) Away from the building, x the Bunk Floor to the door gable using 1x40mm screw Block A (No.
  • Page 7 Please retain product label and instructions for future reference Step 12 Step 14 Parts needed - Parts needed - & x2 & Pre drill Pre drill hole hole Place the Bunk Floor (No. 6) Line the Support Block x2 (No. 18) onto the framing.
  • Page 8 Please retain product label and instructions for future reference Step 18 Step 16 Pre drill Pre drill Cut felt into 3 sheets and lay onto hole hole Once the roof is tted and the building roof as shown in diagram ensuring is square, secure the building to there is a 50mm overhang around the Floor xing the panels onto the oor...
  • Page 9 Please retain product label and instructions for future reference Step 19 Step 21 Parts needed - x2 & x2 & Parts needed - x3 & & & Pre drill Pre drill hole hole Fix the Fascia 1427mm x2 Place a Window Frame Cross (No.
  • Page 10: After Treatment

    Please retain product label and instructions for future reference It is ESSENTIAL that you apply wood treatment immediately after the building has been assembled. AFTER TREATMENT: score around protective cover on glazing and carefuly peel covering back Playhouse Maintenance: It is recommended that the following checks and maintenance are carried out at the begin- ning of each season as well as at regular intervals during the usage season.