Table of Contents
Advertisement
Installation and operating manual
2. Product information
2.1. Intended use
The METPOINT
UD01 plug-on display is compatible with all 4 ... 20 mA transducers equipped with a 2-wire
®
analogue output. It is designed for installation between the transducer and the cable box and is instantly ready
The
for use.
METPOINT
programmed parameters are stored in EEPROM so that they are not lost in the event of a power failure. A dialogue
warning is displayed if the limits at either end of the range are exceeded. The integrated diagnostic system
continuously monitors all display functions.
The device is not suitable for operation in potentially explosive atmospheres
and must only be used for the intended use. The manufacturer shall not be liable for damage caused by improper
use or unauthorised modification of the device. Any such use or modification shall void all warranty.
2.2. Type plate
The type plate is attached to the device housing. It contains all relevant technical data of the METPOINT
plug-on display. Please have these details to hand when contacting the manufacturer or supplier. The operating
system software version (e.g. P07) of the device is displayed for approx. 1 second on the display after switching on.
Please note down the version code to have it to hand for any queries.
METPOINT® UD01
S/N
P/N
PIN 1: +U
PIN 3: I
Input/output: 4 ... 20mA / 2-wire
Supply voltage: +Uv=24 VDC
NOTE
Type plate
Do not remove or cover the type plate and protect it against damage.
6
UD01 is freely programmable using a menu system operated by two buttons. The
®
v
OUT
Product description
Serial number
Product number
Voltage input (+U
)
v
Current output (I
)
OUT
Input/output signal
Power supply
EN
UD01
®
METPOINT
UD01
®
Advertisement
Table of Contents
