Table of Contents
Advertisement
Installation and operating manual
2.11. Unit
The unit of the displayed value is factory-set and indicated on the area where the unit label can be placed.
2.12. Menu list
12
Menu 1 – Password protection
If password protection is enabled, "PAon" is shown on the display.
To disable password protection: Simultaneously press >>▲<< and
>>▼<< to confirm menu option "PAon". Then press >>▲<< or >>▼<<
to enter the password and confirm by pressing both buttons. Password
protection is now disabled and "PAof" is shown on the display.
If password protection is disabled, "PAof" is shown on the display.
To enable password protection: Simultaneously press >>▲<< and >>▼<<
to confirm menu option "PAof". Then press >>▲<< or >>▼<< to enter the
password and confirm by pressing both buttons. Password protection is now
enabled and "PAon" is shown on the display.
The factory-set password is "0005".
The password can be changed in special menu 4.
Menu 2 – Setting decimal point position
Simultaneously press >>▲<< and >>▼<< to confirm menu option "dP". Then
press >>▲<< or >>▼<< to set the decimal point to the correct position and
confirm by pressing both buttons.
Menu 3 – Setting zero point
Simultaneously press >>▲<< and >>▼<< to confirm menu option "ZP".
Then press >>▲<< or >>▼<< to set the zero point and confirm by pressing
both buttons.
The set value is displayed when the electric output signal of the transducer is
4 mA (zero point).
Menu 4 – Setting end point
Simultaneously press >>▲<< and >>▼<< to confirm menu option "EP".
Then press >>▲<< or >>▼<< to set the end point and confirm by pressing
both buttons.
The set value is displayed when the electric output signal of the transducer is
20 mA (end point).
Menu 5 – Setting attenuation (filter)
Simultaneously press >>▲<< and >>▼<< to confirm menu option "FILt".
Then press >>▲<< or >>▼<< to set the time constant of the analogue low-
pass filter and confirm by pressing both buttons.
Value range: 0.3 ... 30 s
This parameter ensures constant display, even if the measured values
fluctuate greatly.
Menu 6 – Enabling/disabling range exceedance alarm
Enable/disable alarm: Simultaneously press >>▲<< and >>▼<< to confirm
menu option "HILo". Then press >>▲<< or >>▼<< to set the exceedance
alarm function to "on" or "off" and confirm by pressing both buttons.
EN
METPOINT
UD01
®
Advertisement
Table of Contents
